How to change diesel engine

1. Hygiene cleaning. Remove the insulation and clean the machine. Clean dirt, debris, grease, and wash your face thoroughly. During the process of cleaning, cleaning and cleaning, loose nuts, rivets, and defects on the exterior can be found and replaced and repaired.
2. Rotate the oil indicator. Any diesel engine engraved with the "Winter and Summer" rotation indicator in the lubricating oil circuit (generally installed at the filter) should be rotated to point to the word "summer" in order to realize a large oil circulation. In this way, the oil temperature can be effectively avoided and the oil pressure can be reduced and the wear of the machine parts can be reduced.
3. Change the oil. Due to the large number of diesel engine types, specifications and models, and the requirements of the used oil are not consistent, two kinds of replacement methods are proposed: (1) If there is no explicit requirement for oil in the diesel manual, or if there is no “winter or summer” distinction, it shall be When the diesel engine is hot or after the operation is completed, the water temperature is about 80 degrees, and the engine oil is released. The oil is precipitated for not less than 24 hours and then used again. Precipitated oil base should be drained and new oil should be added when the amount of oil is insufficient. 2 In the diesel manual, if there is winter or summer oil, the engine oil should be replaced and used. The method is: to make the water temperature of the diesel engine reach eighty degrees, and then put the engine oil on hot oil (be careful not to burn hands). Wait 30 minutes, tighten the drain plug, add the same amount of diesel oil to the oil pan, and run at medium speed for 1 to 2 minutes. The cleaned diesel oil will be released and used for washing. In this way, the oil can be drained and cleaned, and the oil passage can be unimpeded, which creates the conditions for the fault-free operation of the lubricant. Add summer oil.
4. Clean three filters, three nets. Air filters, diesel filters, and oil filters are commonly referred to as triple filters. The main points of attention when cleaning the three filters are: 1 The three-filter is a paper filter, and it is best to replace the new ones with the exception that the air filter is available after cleaning. 2 Metal filters, filter elements, can only be cleaned with clean oil, brush or gas cylinder, use gas to blow out dirt, must not be fired. "Triple-net" refers to the filter of diesel filling port, oil filling port, and exhaust gas outlet, and should be thoroughly cleaned to ensure smooth access.
5. Use zero diesel. The recent weather is characterized by a rapid rise in temperature, and the adaptability of diesel engines to fuels is getting better and better. The use of zero diesel fuel can reduce costs and increase farmers' income.

Description:

Diazinon is an organophosphorus insecticide for veterinary fields for the control of a wide range of animal ectoparasites including scabs, fly strike, lice, ticks, keds and other ectoparasites of cattle and sheep. 

Notes for dipping: 
Do not mix with any other dip. 
Replenish the bath as directed when level falls. Another case animals passing through the bath at a low level will not be as effectively treated as those animals treated earlier. 
Animals must be completely immersed once for at least one minute. 
Care should be taken that animals do not swallow the wash. 
As product Contains organophosphorous compounds, an interval of at least 14 days should elapse between dipping and dosing with any drench containing an organophosphorous compound. 
Animals should never be dipped on a full stomach or when heated, tired, thirsty or suffering from wound or open sores. 

Diazinon 60%

Diazinon Insecticide,Diazinon Solution,Diazinon Insect Spray,Diazinon Liquid

Hebei Kexing Pharmaceutical Co., Ltd. , https://www.kexingpharma.com