Potato Processing Technology

Can be directly sold or cold storage, can also be dehydrated. When dehydrating with a dryer, the parameters such as temperature, time, air volume, and humidity must be mastered to prevent coke drying, roasting or rot. Processing equipment configuration: The processing equipment used by general farmers or small-scale edible fungi plants includes branch slicer, crusher, mixer, bottling (bag) machine, disinfection and sterilization equipment, and drying equipment. Branch slicing machine: There are mainly ZQ-600 type and MG-700 type. The engineering principle is as follows: During the work, the belt pulley is driven by power, the knife is rotated by the main shaft, the knife is equipped with a flying knife, and the feed port is equipped with a bottom knife. The wood is fed from the feed inlet and cut into wood chips by a flying knife. Due to the inertia force and the suction and polishing action of the blade on the cutter plate and the knife cutting action of the bed knife, the wood chip is quickly ejected from the discharge port under the body. Before the machine is used, the flying knife should be adjusted in the same plane. The distance between the flying knife and the plane of the cutterhead is 4-5mm (ZQ-600 type), 6-10mm (MG-700 type), flying knife and bedknife. The gap is 0.3-0.8 mm. Crushers: The crushers are mainly 9FT-40 type and 9FQS-40 type. In addition to crushing wood chips, they can also crush crop straw and feed. The working principle is: the power drives the spindle to rotate through the belt pulley, and the wood chip enters the crushing chamber from the feed inlet. It is cracked after being struck by the high-speed rotating hammer. It is thrown to the circumferential tooth plate and cracked again. Then it collides with the discharge plate. It was bounced back and hit again with a hammer. After so many repeated blows and impacts, the wood chips or materials are crushed into small particles. Under the action of a high-speed rotating exhaust fan, the crushed sawdust is sucked through the sieve and sent out of the machine through the discharge port. Stay in the crushing room to continue crushing. Multi-purpose WJ-70 type raw material mixer: This machine can stir 100 kg of water-containing culture material each time, each stirring for 2 minutes, and it can be operated 8-10 times per hour, and the mixing culture material can be 800-1000 kg/hour. When working, mix and stir the raw materials and water into the drum, cover the drum cap, close the clutch, and start rotating the stirring shaft. The stirring board carries the animal material in the drum to make up and down turn and axial reciprocating motion to achieve a uniform mixture. The purpose of the material.

Eu Standard Tea

Eu Standard Tea,Eu Standard For Tea,Tea Leaf

Chunme Tea,Jasmine Tea Co., Ltd. , http://www.nbblacktea.com