Use the shutter machine should pay attention to the following ten safety issues
1. According to the length of the greenhouse, width, crown and straw weight, according to the standard selection of the appropriate host, pay attention to the remaining load, prohibit full-load and overload operation, and take the necessary safety and security measures for the motor.
2. According to the weight of the roller blind, according to the standard, the support rod, push rod, reel rod, and Luo bolt are used to avoid the unreasonable installation of the rod element causing the folding rod and the twisted rod. During the start-up and operation of the host computer, it is forbidden to stand in front of the host computer and the roll bar in case of a personal safety accident caused by the loss of control of the roller blind.
3. Motors, cables and other electrical distribution equipment purchased by users themselves should be qualified products that meet the national standards to ensure safe electrical operation and safe operation of the host.
4. It is forbidden to fix the reverse switch on the main unit and the support rod. To stay away from the host, observe the edge on the back wall or both sides. In addition, the control switch is added in front of the reverse switch to ensure that the power can be cut off in time when the reverse switch fails.
5. The host must add enough qualified heavy-load gear oil when it is used for the first time, check regularly and replace it once a year.
6. Straight tooth rolling shutter When the power fails, users are forbidden to raise the brake block to allow the shutter to slide down. Otherwise, there is danger of life. The pull-up roller shutter is equipped with a remote control to stop immediately when the body or clothing is “bitedâ€.
7. In case of rain and snow weather, it is necessary to cover the rainproof membrane to prevent the wet and overweight of the straw curtain from causing damage to the host and the motor.
8. It is forbidden to touch the V-belt when the roller shutter is unwound, and the shutter must be shut down immediately after being rolled into place to prevent the straw screen from turning over into the booth.
9. During the installation and use, if there are deviations in the poles and coils, they should be adjusted, straightened, and tightened in time to ensure normal operation of the main unit and the rods and to prolong their service life.
10. In the event of a failure of the roller shutter, it is necessary to solve the fault at the point of assistance or guidance of the agent or the company service personnel to avoid blind operations leading to safety accidents.
Environmentally Straw Cup,Straw Cup,Wheat Straw Cups,Wheat Straw Drink Cups
Yangzhou Tongfun Red International Trading Co,Ltd. , https://www.i-ecbio.com