High speed disperser operating procedures
2023-01-11 09:06:05
First, prepare before starting the machine
1 Check if the hydraulic oil level is normal and the low should be added to the specified oil level.
2 The impeller should be turned flexibly by hand, without friction.
3 Check whether the fasteners are loose and whether there is leakage at each sealing part.
4 Turn on the main motor and check that the direction of the agitation is the same as the direction specified by the device. There are no abnormal noises and abnormal vibrations.
5 Confirm that the above inspection work is correct before starting the production.
Second, boot
1 Place the impeller in the center of the barrel and press the down button to lower it to the lowest position or the desired position.
2 Turn on the main motor, press the required speed, and adjust the button to the appropriate speed.
3 During the operation, always pay attention to the machine for abnormal noise and abnormal vibration. If abnormal noise and abnormal vibration are found, stop the vehicle to check the cause and take measures to eliminate it before continuing work.
Third, stop
1Press the parking button to stop the impeller.
2 Open the up button to raise the spindle impeller to the top of the barrel. After pushing the barrel, clean the impeller.
3 When it is raised, it cannot reach the top of the ceiling, prevent the hydraulic oil pump from overpressure and damage the hydraulic pump.
When 4 liters, the impeller can not touch the protruding part of any other equipment to prevent deformation of the machine impeller and damage to the balance of the fuselage.
5 When there is no object, the rotating shaft and the impeller should not be prevented from falling down to prevent damage to the impeller or the shaft or deformation.
Fourth, high-speed dispersing machine use precautions
1 It is forbidden to contact any rotating object except the object in the barrel. When rotating at high speed, any solid object may wrap around the machine shaft and cause damage.
2 It is forbidden to idling the high speed of the dispersing machine over 800r/min , which may cause deformation or severe vibration of the rotating shaft, or it may break and fly out.
3 When feeding, all kinds of packaging bags should be away from the running shaft to prevent entanglement accidents.
4 Prohibit long hair and other items that may be entangled near the running machine.
5 When manufacturing, the operator close to the machine must have another person guarding in front of the chassis to prevent an emergency and not stop immediately.
6 There are solid blocks or other things that fall into the mixing tank and should be stopped immediately before being taken out.
7 If the equipment is not used for long-term parking, the power must be cut off and all scrubbed clean.
8 If overheating or abnormal noise is found during use, it should be checked in time.
9 Regularly inspect consumables, such as bearings, oil seals, etc., and find that they are worn and replaced immediately.
10 Do not splash water on the electromechanical box.
For more information on dispersing machines, please visit:
Frozen Swimming Crab,Blue Swimming Crab,Frozen Crab Whole,Portunus Trituberculatus Crab
Zhoushan Haiwang Seafood Co., Ltd. , https://www.haiwangseafoods.com