Lubrication of the five major parts of agricultural machinery can not be ignored
First, the clutch release bearing clutch is used very often, easy to damage, the driver should deal with the clutch release bearing maintenance before each quarter of the work, remove the separation claw and the separation of bearings, with diesel or kerosene cleaning and drying, into the calcium The base grease is heated in the container so that the hot grease penetrates into the bearing and can be removed and installed.
2. Sleeve Axle Bushing Sleeve Axle Bushing is working under the harsh environment with many dust and moisture, and it is easy to wear or pull. During maintenance, remove impurities such as sand grains embedded in the sleeve and add calcium-based grease to lubricate. If the sleeve wears badly, replace the new sleeve.
3. Rotary cultivator coulter shaft bearing walking tractor The 308 bearing on the right side of the rotary plough coulter shaft with the coulter gearbox is lubricated with gear oil. Some operators ignore the left 207 bearing to use calcium. Based on grease lubrication, this will cause the bearing to dry out of oil, heat stuck in the operation, and even make the bearings run in a circle, the journal severely damaged and scrapped. Therefore, the oil seal and bearing on the left side of the coulter shaft should be removed during the maintenance. After cleaning with diesel oil, add calcium-based grease.
Fourth, the ditching machine depth limit wheel bearing walking tractor with the disk ditch depth limiter wheel fittings are equipped with two 60204 bearings at both ends, the bearing is equipped with a cover waterproof, do not think that the depth of the wheel can turn Without maintenance, the maintenance of this part will not be strengthened at ordinary times, which will cause the axle to become stuck. The maintenance of the site can be done after the end of each season, remove the lower limit deep wheel, remove the 60204 bearing cleaned in clean diesel, and then add calcium-based grease lubrication.
Fifth, the thresher roller bearings threshing machine roller bearings in dusty, high humidity conditions, do not think that the drum can rotate to ignore the maintenance, otherwise it will lead to early wear and even scrap roller journal. Before each quarter of operation and during operation, attention shall be paid to the inspection of the thresher roller bearings. The driver shall lubricate the grease in time, and the bearings shall be worn out or damaged in time.
Liga-Lok Ligating Clips,Titanium Ligating Clips,Hemolock Surgical Clips,Weck Hemoclip
Qingdao DMD Medical Technology Co., LTD , https://www.conston-tech.com