How to use low speed large capacity multi-tube centrifuge
2021-06-19 13:05:29
First, the operating procedures:
1. Plug in the power, the standby indicator lights: Turn on the power switch, the flashing number displayed by the digital tube of the speed control and timing system is the factory setting of the working speed of the machine.
2. Set the working parameters of the machine, such as working temperature, running time, working speed, etc.
The operation button on the control panel starts the centrifuge. During the preset acceleration time, the rotation speed rises to a preset value.
During the preset operating time (excluding the deceleration time), the centrifuge starts to decelerate and its speed drops to zero within the preset deceleration time.
Press the stop button on the control panel, the digital tube displays dedT, and the flashing speed value will be displayed after a few seconds, when the machine is ready for the next work.
Second, note:
1. Except for running speed and running time, do not arbitrarily change the working parameters of the machine to avoid affecting machine performance.
The speed setting must not exceed the high speed of the Zui to ensure safe operation of the machine.
If 0.00 or other digits appear during use, the machine will not be turned off, and should be turned off and off. After 10 seconds, turn it back on. After the set speed is displayed, press the operation button again and the machine will run as usual.
Do not open the door while the machine is running or when the rotor is not stationary.
The centrifuge must fill the sample in equal amounts and do not allow the rotor to operate under unbalanced conditions.
Do not use the centrifuge for more than 60 minutes.
The centrifuge must be grounded reliably; if the machine is not in use, unplug the power cord.
1. Plug in the power, the standby indicator lights: Turn on the power switch, the flashing number displayed by the digital tube of the speed control and timing system is the factory setting of the working speed of the machine.
2. Set the working parameters of the machine, such as working temperature, running time, working speed, etc.
The operation button on the control panel starts the centrifuge. During the preset acceleration time, the rotation speed rises to a preset value.
During the preset operating time (excluding the deceleration time), the centrifuge starts to decelerate and its speed drops to zero within the preset deceleration time.
Press the stop button on the control panel, the digital tube displays dedT, and the flashing speed value will be displayed after a few seconds, when the machine is ready for the next work.
Second, note:
1. Except for running speed and running time, do not arbitrarily change the working parameters of the machine to avoid affecting machine performance.
The speed setting must not exceed the high speed of the Zui to ensure safe operation of the machine.
If 0.00 or other digits appear during use, the machine will not be turned off, and should be turned off and off. After 10 seconds, turn it back on. After the set speed is displayed, press the operation button again and the machine will run as usual.
Do not open the door while the machine is running or when the rotor is not stationary.
The centrifuge must fill the sample in equal amounts and do not allow the rotor to operate under unbalanced conditions.
Do not use the centrifuge for more than 60 minutes.
The centrifuge must be grounded reliably; if the machine is not in use, unplug the power cord.
Hunan Kangfutai Medical Devices Co., Ltd. , https://www.3kfut.com