Flower soft branch cutting method
Cuttings are the main method of flower propagation. They are fast and cultivate early. Generally, we cut the cuttings from the late May to the end of September in the plant growth period as soft branch cuttings. The cuttings are full-grown mature branches in the spring and most of the flowers are evergreen. Flowers and most deciduous trees can be cut with softwood cuttings. This is a good time for cutting flower branches.
During the growing season of flowering plants, collect semi-lignified twigs with full growth and development in the current year. Cut along with the cuts, remove the overly tender parts and cut them in sections of 2-4 sections. Each section is about 10 centimeters long. ~ 2 blades, then use a knife to cut or slash the mouth 1.5 to 3 mm below the base section. Cuttings treated with plant growth regulators promote early rooting.
The soil used for softwood cutting requires loose soil and good drainage. It can be mixed with a large amount of river sand. Before the cutting, the soil should be disinfected. 50% carbendazim can be made into 1000 times solution, and 50 to 60 grams of carbendazim can be added to 1 ton of soil. The amount of spray, spray it and mix well, sealed with a membrane for 2 to 3 days, can kill a variety of bacteria in the soil. In the cutting process, first use big wooden sticks to make holes, then insert the cuttings into the holes, insert them obliquely at an angle of 45 degrees or vertically, and insert three to three fifths of the cutting depth. After inserting, compact the surrounding soil and insert them into the soil. Close contact. Softwood cuttings require high air humidity, so it is best to use it on a cloudy day. After the cuttings are done, they must be filled with water, covered with a plastic film to moisturize, and shaded. The most suitable cutting temperature for general cutting is 20 to 28 degrees Celsius. When the temperature is relatively high, attention should be paid to ventilation and ventilation. Generally, the two ends of the film are uncovered, and the proper constant temperature and high air humidity are maintained. General insert 10 to 20 days after the rooting.
Bed Head Unit For Ward
The Medical Bed Head Unit is made of aluminum alloy sections, of which the surface is treated with acrylic painting or electrostatic spray. It is equipped with the dismountable panel, three built-in cabling channels for gas, strong electricity and weak electricity, and external leakage protectors, bedside lamps, large toggle switches, five-hole multi-function socket, gas terminal and Medical wards calling system. The hospital can choose the appropriate color in line with the environmental requirements.
Bed Head Unit For Ward ,Bed Head Panel ,Hospital Bed Head Panel,Mural Bed Head Unit
Hunan Eter Medical Co., Ltd. , https://www.eter-tech.com